The pin is held in with two monel cotter pins. Martec strongly suggests not using stainless ones.

Martec removal easy - remove 2 cotter pins that hold the prop pin, gently drive pin out with drift punch and hammer or plastic mallet, take off blades (note there is a. Hatsune Miku Clock Widget Download Free. A great reference for inboard engines and mechanical systems (and most things on a boat) is Nigel Calder's 'Boatowner's Mechanical and Electrical Manual. Carefully line up pivot pin holes in hub and blades. Important note: One blade and one ear of the hub clevis are marked 'I' and should be assembled with both marks on the same side to insure proper balance. Install Monel pivot pin, and lock it in place with the remaining (2) Monel cotter pins.

Contact them to get the right ones. Same ones are used on the prop nut so get four. What he said. Furthermore: Assembly onto the prop shaft is not quite as straight-forward as one might think.

Contact Martec for installation instructions. Be advised that Martec props, any folding or feathering prop, actually, can be. We just had to send ours in for a refurb last winter because it had developed the 'Martec blues.' Btw: A fellow club-member suggested giving all the surfaces that bear on one another a good coating of marine-grade lithium grease to prolong the time-between-refurb intervals. Says it's worked for him.

I didn't see how it could hurt, so I went ahead and did that on ours. 10 Feet Super Stomper Download Google there.